If the region setting exists then it will override the OpenSim.ini setting. This setting can also be used in the section of OpenSim.ini. This will affect resizing of existing prims. This is a single number which applies to X, Y and Z co-ordinates. The maximum dimensions for a non-physical prim. The maximum dimensions of a physical prim. Max prims per user (per parcel).Negative values will disable the check. ![]() Due to LL protocol constraints, the maximum limit that can be shown is 45000. However, this limit is not currently enforced by OpenSimulator. The maximum number of prims that the region will be listed as supporting. As of this option only exists in the current git master. The maximum number of agents that can be in the in the region at any given time. On Unix, you can also use the uuidgen command.Īs well as the critical entries above, there are some additional optional ones that can change the properties of a region. by changing one character so that the new one is in the range or a generator can be found at uuidgen webpage. To create a new UUID you can either tweak an existing one by hand (e.g. Other than that, the details are the same. It has a different location (1000,1001) and a different InternalPort (9001). RegionUUID = 5c445740-6460-43d3-ba4c-444444445555Īs you can see, the Second region is named Greek Wedding and has a different UUID. Here's an example where a second region has been added to Regions.ini or use the create region command on the region console (I don't recommend this since it seems to be a bit buggy).create an old format OpenSimulator xml file (these still work with current OpenSim).If you want to add another region you can The region size, must be a multiple of 256, and equal. (must be the same for all regions on file) ![]() IP port for all incoming client connections.Įxternal IP Address of the router or FQDN. Alternatively, you can set to a specific IP. The (x, y) location of the region on the grid.Ġ.0.0.0 if you have more than one NIC on the server and you don't care which IP address OpenSimulator listens on (this is the usual setting). ![]() For more details, see Configuration#Running OpenSimulator for the first time. When you start OpenSimulator for the first time without an existing Regions.ini file, you'll be asked for an entry for each setting in order to set up your initial region. This is a list of settings that must be present for a region to operate. If you started a completely fresh installation of OpenSim, it will ask you a series of questions to set up your first region.
0 Comments
Leave a Reply. |